Two things kill giant hogweed for good. A systemic herbicide put on the leaves or painted onto freshly cut stems, and a shovel that lifts the root crown out of the ground with the plant. Every plan for killing giant hogweed comes down to one of those two, because the plant grows back from whatever you leave behind in the soil. Virginia Cooperative Extension says to leave this work to people with training, experience and the right gear. So read what follows as how the job gets done, not as a push to go and do it yourself.
Fresh leaves stood on the cut stumps three weeks after a mower went through a roadside patch. I counted about a dozen plants when I checked that spot, and every stump had pushed new growth from the base. Mowing does not kill this plant. It only stimulates budding, so a cut stem answers by sending up more shoots than it carried before. You end up with more stems than you started with.
The root crown sits right at the soil line, and it holds the buds that carry the plant's next round of growth. Take the top off and leave that crown in place, and you have pruned a weed rather than killed one. New leaves show up within weeks. That is why cutting and mowing both fail on their own. Strip off green growth without reaching the crown and you buy a few weeks, then hand the plant its own root system to rebuild from.
A giant hogweed herbicide has to be systemic, which means it travels down through the plant and into the root. Wisconsin DNR lists glyphosate at 2.5% active ingredient, triclopyr, or metsulfuron methyl at 1.5 oz (43 g) per gallon (3.8 L). You put any of them on as a foliar spray over the leaves, or straight onto stems that have just been cut. Timing carries as much weight as the product you pick, and the plants need treating before they set seed.
Digging out hogweed suits a small stand of plants, and a sharp shovel does the whole job. Slice the root 1 to 2 inches (2.5 to 5 cm) below the soil surface, lift the crown out with the plant, and finish before seed sets. Big plants come apart easier if you cut them down with loppers first. The crown and the roots still have to come out after that. Leave them and the stump re-sprouts, which puts you back at the start with a season gone.
So which one do you use? Both routes to killing giant hogweed start the same way, with a count of the plants. A few stems along a fence line come out with a shovel in one pass, and that is an afternoon of work for a crew. A patch that has run down a stream bank or across a field needs spray, and it needs someone who sprays for a living. Get to the plants before the flowerheads open either way, since seed is what turns a small job into a five-year one.
- Bag: Put flowerheads and plant parts into bags and send them out with your regular trash.
- Burn: Burning the flowering heads works as the other route, or you can bag them for the landfill.
- Watch: Check the site for three to five years so the seed bank in the soil runs out.
- Nothing eats this problem for you, since no classical biological control agents are approved.
Where the cut flowerheads go decides whether you meet the same patch next summer. Seed in the ground outlasts every plant you pull out of it. Your follow-up counts as much as the first pass, and three to five years of checking the site is the honest number. University of Maryland Extension calls for a licensed pesticide applicator here, and that is the call I make.
Read the full article: Giant Hogweed: How to Spot It and Stay Safe