You plant a hedge as one long run, not as forty shrubs put in one at a time. Mark your line with string, dig a trench along it, set each plant to its old soil mark, then cut the new tops down hard and finish with mulch and water. Planting a hedge in that order gives you a green wall in a few years instead of a gappy row that never fills in.
"All forty bare-root? In that clay?" The nursery manager told me the ground would fight back, and the ground did. Bare-root stock is the cheapest way to buy a hedge, and your window for it is short. Late March to mid-May, before bud break. I planted the whole run in clay that came out of the trench in wet slabs, and every plant still went in dormant.
Bare-root hedging arrives as a bundle of bare sticks with naked roots and no soil at all. Container-grown and balled-and-burlapped plants cost you more, and what you buy with that money is a hedge that looks like a hedge on planting day. On a long run you want the bare-root. You get more plants for the same money, and on a hedge of any length that settles the choice for you.
Run a string line the length of the hedge and stand every plant along it before a spade goes in the ground.
Dig one continuous hedge planting trench down the string, wide enough for the roots to sit out flat.
Hold each plant so the root collar sits level with the surrounding soil, then backfill and firm the soil in.
Take new bare-root deciduous plants down to 4 to 6 inches (10 to 15 cm) above the ground.
Spread 2 to 3 inches (5 to 8 cm) of mulch over the strip and water the whole run deeply.
A trench does one thing a row of separate holes cannot. Roots leaving a single hole reach an undug wall of firm ground at the edge, and stall there or circle back. Dig one continuous hedge planting trench and your roots run out into loosened soil in every direction. The plants knit together underground long before you see the tops touch. Make the trench wide enough that the roots sit out flat.
Keep bare roots covered and damp until the moment each plant goes in the trench. Roots left lying out in wind or sun dry out fast.
Depth is the part of planting a hedge that most people get wrong. Set the root collar level with the surrounding soil, no deeper. Bare-root plants carry a clear mark on the stem where the soil sat in the nursery, so line that mark up with your ground before you backfill. Then cut the tops back. New bare-root deciduous plants go down to 4 to 6 inches (10 to 15 cm) above the ground, and shrubs already one to three years old go to 3 to 5 inches (8 to 13 cm).
That first cut looks brutal on a plant you paid for an hour ago. Do the cut anyway. Hard pruning at planting is what pushes vigorous low branching, and low branching decides whether you can see straight through the base of your hedge at ankle height. Cut the whole run to the same height on the same day, and you will shear a level hedge for the rest of your life.
The last step of planting a hedge is the one people skip when the light goes. Mulching a hedge does more than tidy the strip up. Lay 2 to 3 inches (5 to 8 cm) of shredded bark, leaf mold or compost in a band down the whole run, not a neat ring around each plant, and keep the mulch back off the stems. A full band holds moisture in your soil and keeps weeds away from young roots.
Then water, and keep watering. Your new hedge needs a deep soak through the first one to two years, not a daily splash that wets the surface. Push a finger under the mulch before each soak, because clay holds water far longer than sand. Leave the shears in the shed after that hard first cut, because you give the plants no further pruning until the following spring. For how far apart to set your plants, see the spacing answer, since a formal sheared hedge goes in much tighter than an informal run.
Read the full article: Hedges: Plant, Shape and Keep Them Dense