No. Boiling water kills the leaves and stems you soak, and the kill stops there. Pour a kettle over a vine and the top growth goes limp inside a minute, which looks like a win. Used as a boiling water bindweed treatment, your kettle is a very fast trim. The roots under your feet keep their stored food and their buds, then push fresh shoots through the same ground a few weeks later.
The vines were back around my own fence post in under three weeks, twisting up the same wire. I had walked that run with a full kettle in each hand and soaked every crown I found. What I could not soak was the neighbor's gravel alley beyond the fence, and one plant can spread more than 10 feet (3 m) sideways in a single season. The roots under that alley never felt a thing.
Scalding weeds works by contact and by nothing else. Water leaves your spout at 212°F (100°C). Soil insulates well, so most of that heat soaks into the top inch or two (2 to 5 cm) before the rest bleeds away. UC IPM puts 70% of bindweed root mass in the top 2 feet (60 cm), with roots able to make buds as deep as 14 feet (4 m). Your kettle never gets near them.
Those bindweed root buds are why the plant comes back on a schedule. Lateral roots grow buds along the whole length, and each bud can send up a fresh vine or run sideways as a rhizome, depending on how deep the bud sits. Take the top off and the plant rebuilds a whole shoot system in about 3 weeks. On a young plant grown from seed, buds can form within 4 weeks of the seedling coming up, so your window for a clean kill is very short.
The regrowth also draws on reserves you cannot reach. Vertical roots run 20 feet (6 m) down or more, and that stored food pays for every new shoot. Scald one patch of ground while the vines beside your path stay untouched, and the plant carries on from the untreated side. This power to regenerate is why bindweed holds your ground season after season.
There is one job your kettle does well. Bindweed in paving cracks, or a lone seedling on a gravel path, sits in thin, shallow grit with no reserve of established root beneath. Boiling water can finish a young plant there, and you get no residue left behind on the stone. A boiling water bindweed drench will not clear a bed. In ground that has carried the weed for a season or more, you are pouring hot water on a root network that spreads faster than you can carry kettles.
Carrying a full kettle of boiling water across a garden is a real scald risk, and the danger grows when you crouch to aim between plants. Boiling water has no aim at all, so seedlings and low leaves you splash die along with the weed. Treat a boiling water bindweed pour as a spot fix for a seedling and nothing more. For an established patch, put your effort into pulling regrowth every 2 to 3 weeks or covering the ground with cardboard and mulch for three to five years. Both jobs work on the same weakness, which is a plant that has to keep spending food to replace lost shoots. Bindweed still takes years to wear down, and your site may never be fully clear.
Read the full article: How to Get Rid of Bindweed: 7 Real Fixes